The Corus PTZ is a key element in the whole Actaris chain, from the meter to the billing data, because it converts the actual volume measured. For each FLUXI TZ and DELTA meters, correction according to pressure, temperature and compressibility factor (meaning the transformation in real. CORUS is an electronic volume converter dedicated to commercial and industrial applications. It converts the actual volume measured by the gas meter to.
|Published (Last):||7 May 2013|
|PDF File Size:||19.78 Mb|
|ePub File Size:||11.38 Mb|
|Price:||Free* [*Free Regsitration Required]|
Period 1 second Retrans.
During the main cut, the internal backup battery will ensure the total functioning of Corus PTZ and the battery counter will be decreased with the same management described in the “battery alarm” chapter.
The tamper input can be set into one of the following modes: This alarm is not metrological and is dedicated to the control of the whole metering chain. When the battery reaches the end of its life, it has to be replaced according to the following phz that ensures a non-stop operation of the product: Six 6 different menus are available including following parameters: Thanks to its accurate piezo-resistive pressure sensor and its 4 wires PT temperature probe, CORUS provides an accurate conversion on the whole temperature range.
The fixed part includes the following data: Crus allows to check the good operating of the metering function and of the pulse emitter of the meter. Create your own integration Not supported yet? Its volume input is a low frequency one that can be connected to any Ex compliant gas meter that provides such information. The Octopus gateway is a Modbus data logger that comes with 6 x digital inputs, meaning that up to 6 pulses outputs can be counted, logged and communicated to Wattics dashboard.
Place the metrologic cover and seal it?
EnergoBit / Gas Volume Converter CORUS (PTZ)
We would like to thank all our customers for your continued support over the last 5 years. Enable our cloud-based energy analytics and dashboard for your gas meter readings, to discover, measure and verify savings in the premises you manage. The corresponding marking is: This battery includes all protections required by intrinsic safety and cannot be ataris for a different type. Following the installation procedure, Corus PTZ has to be carefully closed using the four screws placed ;tz each corner.
Itron Corus Gas Volume Converter
vorus It operates at baud, baud, baud, baud. Corus PTZ is approved according the new European standard EN and it can be used for commercial and fiscal gas transactions.
That LF input can be associated to any gas meter with an electrically compliant interface: Solenvis carry out an extensive meter upgrade project at Oxford University. Specific value for some event only?
Corus PTZ manages three pressure alarms: Solenvis continue to supply meters and services to RWE nPower. Once the configuration is completed and your data points are registered and subscribed to Wattics, you will receive access to your Wattics dashboard, and from then on will be able to log in to your Wattics Dashboard at http: Date and time of the event? The RS port is by default in a power-down mode.
This port can be used for serial asynchronous start-stop half-duplex communications. CE marking and data required by the potentially explosive atmospheres regulation Title: When xorus display is on, the acquisition of pressure, temperature and the calculation of compressibility and conversion factor is performed every second.
All daily consumptions are stamped from the gas hour to the gas hour of the next day. These two actions are mandatory to achieve a correct water tightness of the enclosure. This label is inviolable: Base volume outputs are ltz disabled as long as any metrological alarm is active.
The tamper input can be put into one of the following modes: The alarm outputs can remain active: At a programmable period from 1s to 30s if the display is off same period than P and T acquisition?